You don’t wear your work uniform seven days a week, so why should your car? SIGNARAMA car magnets provide the benefits of mobile advertising and identification, without being permanent. This is also a cost-effective alternative to fully branding your vehicle.
Speak to your local SIGNARAMA branding specialists, to get the car magnet you need today.
Feeling creative? You can design your car magnets online! Start from scratch or choose from our professionally designed templates. This is available for purchase through our online store.
Preparation - The vehicle surface and the brown magnetic side of the sign should be clean, dry, and waxed prior to applying.
Installation - Make contact of one edge of the sign to the vehicle surface in the desired location and then let the adjacent part of the sign contact the vehicle surface until the entire sign is held magnetically to the vehicle. If the sign is not in the desired position, remove the magnetic sign and repeat above. (Do not try to straighten sign by pulling when it is held magnetically to the vehicle. It may stretch the material, especially when hot).
Avoid placing your sign over chrome trim or surface protrusions of any kind. The temperature of the sign should be above 16 degrees Celsius during installation. (The temperature of the vehicle surface does not matter).
Caution - Magnetic vehicle signs will NOT adhere to areas on your car where plastic body fillers have been used. Use caution in applying vehicle signs to areas of your car that have been damaged and repaired in order to avoid losing your signs. Make sure the entire magnet is against the metal surface (no air pockets).
Cleaning – Magnetic signs attract foreign material, and as such, require constant cleaning. We recommend a minimum clean of your sign once a week. To clean your sign, please use warm water and a mild detergent and apply gently with a soft cloth to both sides of the sign and the vehicle area the sign is attached.
Storage - To avoid cracking or breaking, do not fold or crease. Storing your magnetic sign flat is recommended. If stored in roll form, roll must be a minimum of 75 millimetres in diameter and have the lettering on the outside of the roll to prevent wrinkles.